Long Tail Cast-on Method
The Long Tail cast-on method is similar to the e-wrap method except that you use the tail of the yarn to knit off the first row. This creates an even edge instead of a loopy edge like you get with an e-wrap cast-on perfect for ordinary edges.
Tools needed
- Knitting board
- Knitting tool
- Tie a slip knot leaving a
3-inch tail and place it on the anchor peg.
- Wrap the knitting board. See wrap cast-on for
instructions. When finished, add on a
couple of inches to the working yarn and
hold the spot in your hand to keep it
marked.
You need to make sure that you have enough yarn to wrap the length with your tail.
- Unwrap all of the pegs. Make sure to keep a
good hold of the place where you ended.
- Tie a slip knot where you
are holding onto the yarn and place it on
peg 2. Let the long tail fall down to the
front of the loom.
- Follow the directions in the wrap cast-on to wrap the
loom. Anchor the working yarn on the anchor
peg.
- Using the long tail, wrap the pegs needed
for your project.
- Each peg will now have 2 wraps on it.
- Knit off.
Coming soon!